**Important, Do not bleed kit while it is installed on the bike. Bleed brake before installation.
**There can be no tension on the master cylinder arm while bleeding.
** Use only DOT 5 Brake fluid in this kit.

1. Attach the stainless steel brake lines or nylon brake lines to the master cylinder and caliper.
 

2. Remove the red cap from the master cylinder.
 

3. Fill master cylinder reservoir to approximately 1/16" from the top.
 

4. Install bleeder adaptor in the top of the master cylinder.
 

5.  Tighten all bleed screws, then open them 1/2 to 1 turn each.
 

6. Place the nozzle on the bleeder bottle.
 

7. Place nozzle of bleeder bottle on the bleeder adaptor of master cylinder to force
fluid through the system.
 

8. When fluid comes out of the caliper bleed screws, without air bubbles, tighten them.
 

9. Remove bleeder bottle and the bleeder adaptor from the master cylinder.
 

10. Re-check reservoir level and fill if necessary.
***Note always check reservoir level after bleeding and before riding.
 

You can also visit www.BlasterZone.com and click on support for detailed instructions,
including pictures on how to bleed and  install these brakes.